3 Series Thermoplastic Machine
U.T.S. designed and built ride on thermoplastic machine with rotating kettle and head
450+L capacity
Tungsten carbide faced gates are standard.
10 minute swap over.
Spring pin locking of kettle, head and seat assembly. Seat assembly on rollers.
German Grammer air suspension seats – used by CAT.
No hot oil hoses to disconnect.
Using hot oil gear pump – never have to bleed the system.
Fiberglass flip rear cover for good access. Disconnect Deutch plugs to rear lights, remove 2 pivot bolts and take away for full access.
Laser cut and folded chassis bolted together like a truck to negate weld failure. Enormous reduction of flexing.
Utilised as many off the shelf components stocked here as possible. Not on the shelf with suppliers in Aus. we stock it.
Quick compressor and pump belt replacement and tensioning.
Compressor (same as on Borum) on LHS so you can see sight glasses and we stock them and their filters.
Old style wiring and relays. No CAN bus. Any competent auto elec. should be able to fix it.
Arrowboard and beacons, dual footswitches, dual sight pole and head raise/lower switches – standard fitment the list goes on………
Feedback from operators
“It’s a nice machine to operate”
“Very stable”
“You don’t have that big auger assembly in your view”Feedback from maintenance
“Look at that chassis, it’s built for the job”
“That pump drive will never wear out”
